Latex GÉDÉO from Pébéo is a dense and concentrated latex compound made from natural rubber. Suitable for the production of smaller moulds of more complicated shapes. Ideal if you are working on objects with shallow relief. Package contents 1L.
Instructions for use: apply with a brush or by dipping the object
(brush)
1) Apply the latex to the object using a brush and allow to dry for about 10 minutes.
After drying, apply the Latex in the same way in about two to three more coats. Then leave to dry for 6 hours.
2) Remove the object from the latex case when the case is completely hardened.
3) As a reproduction material, you can pour plaster, liquid glass, etc. into the latex mold.
(by immersion)
1) Dilute the latex with one part water.
2) Immerse the selected object in latex for 1 minute, remove and allow to drain.
3) Repeat this soaking process until you have a layer of about 1.5 mm on the object.
4) Wait for the object to dry completely (6-12 hours) before removing the mould.
5) Finally, dust the outside of the mould with talcum powder and remove the mould by turning it inside out.
Tips: For rubber or rubber castings, first grease the mould vaseline. Before using the brush, wash it with spring water before soaking it in latex. To strengthen the latex mould, use a second coat before it dries plaster strips and immediately apply a third coat. You can use a hair dryer to speed up drying. Wash brushes immediately after application in soapy water or soak in thinner.
Didn't find the answer to your question about this product here? Do not hesitate to contact us and we will be happy to answer your question.
PCS | |||||
---|---|---|---|---|---|
Darwi Terracotta self-hardening modeling clay 1kg |
€ 4.36 | In stock | |||
Siligum 300g - silicone mass for molds |
€ 35.16 | In stock | |||
Self-hardening Keraplast modeling compound white 0.3kg |
€ 2.64 | In stock | |||
Darwi Kids modeling clay 1kg |
€ 3.96 | In stock | |||
Modeling spatula, eyelet BigC 08 |
€ 3.40 | In stock | |||
Double-sided design Abig narrower - eyelet |
€ 3.84 | In stock | |||
Lucoprene catalyst N 300g |
€ 27.96 | In stock | |||
Modeling material Darwi Beton 500g |
€ 3.36 | In stock |
PCS | |||||
---|---|---|---|---|---|
Alabaster modeling plaster Kremer 58343 |
€ 5.00 | 1-2 weeks | |||
Lucoprene catalyst N 300g |
€ 27.96 | In stock | |||
Basic set crystal resin 45ml |
€ 7.96 | In stock | |||
Siligum 300g - silicone mass for molds |
€ 35.16 | In stock |
Lacquer Darwi 30ml satin | previous product | Latex molding white 1L | next product | Latex molding white 250ml |